Put a dot of glue at the top of the neck of the bottle, just under the rim, on the rear of the bottle.
Put one end of the twine in the glue. Continue to wrap the twine tightly around the neck in a spiral. Secure the tail end of the twine with anther dot of glue. You can use a hot glue gun instead of the tacky glue.
Download the bunny SVG from RoxySVG on Etsy at https://shrsl.com/2vo0b. Then upload it into the Cricut Design Space software.
Adjust the size of the bunnies so that they are approximately 4 inches tall. (Measure the width of your bottle and adjust the size of the bunnies proportionately so that they fit and/or fill up the width.)
Put the permanent adhesive vinyl onto the green (medium grip) Cricut mat.
Follow the on-screen directions to cut out the design.
Use the Cricut weeding tool to remove the vinyl that is not part of the design.
Remove the backing from the application tape. Smooth it onto the bunnies. Cut apart the bunnies so that each one is on its own tape.
Flip over the bunnies. Remove the backing from the vinyl, so that it is now only stuck to the application tape.
Place a bunny onto the bottle, and press down firmly on the application tape to secure it. Then peel off the application tape in a diagonal direction. Repeat with the other two bunnies.
Use the tacky glue to attach the cotton ball tails.
Add Easter egg sprays, if desired.